Table of Contents
Advertisement
•
Hold by the DE section, do not directly touch the PCA unit unnecessarily.
b. Unpacking
a)
Use a flat workplace, find which side of the pack is up and be careful not to have the
wrong side facing upwards. Do not place the device directly on a hard table, place it
on something soft such as a rubber mat.
b)
Be careful not to apply any excessive force to the packed device when removing the
shock absorbing material.
c)
When taking the device out of the antistatic bag, be especially careful not to apply any
excessive force to the PCA or to the interface connector section.
d)
Never ever remove the DE seal label and screws and the DE cover.
c. Installation
a)
When the power is ON, do not change the switch setting, or connecting, or
disconnecting connectors.
b)
Do not move the device or disconnect connectors with the power ON or until the disk
drive unit comes to a complete stop after the power is turned OFF (about 30 seconds).
d. Packaging
a)
Place the device in an antistatic vinyl bag along with a desiccant (silica gel).
b)
It is recommended that you use the shock absorption cushion material and packaging
that contained the device when it was delivered by Fujitsu.
If the same packaging material cannot be used, use a shock absorbent box that will
transmit shocks directly to the device. When using this type of box, adequately
protect the PCA surface and interface connector section.
c)
Place a label showing which side is up and clearly stating the notes on handling on
the outside of the packaging.
e. Delivery
a)
As a rule, deliver as it is packaged and keep the up side up.
b)
If delivering a single drive after it is unpacked, take it only a short distance. Also, use
shock absorbent material to protect it against shock and vibration.
unpacked device in either of the allowable packed positions. Refer to Section 3.2 in
Product Manual.
1 - 4
C141-F024-02EN
Deliver an
Advertisement
Table of Contents
Troubleshooting
