Table of Contents
Advertisement
Operating instructions
Transferring a key function to the additional switch:
(
1) - Key for sewing backwards
(2) - Key for the position of the needle
(3) - Key for the start and end strips
(4) - Key for the stitch length
(5) - Key for the additional thread tension
(6) - Screw in basic position: slot horizontal
(7) - Screw activates the additional switch (9): slot vertical
(8) - Screws for the assignment of the additional switch (9)
(9) - Additional switch
Figure 25: Transferring a key function to the additional switch
The key function is transferred by turning the screw under the key until it
is vertical. Only one function can be transferred to the additional
switch (9). Therefore only one of the screws (8) may be in the vertical
position (7).
Before transferring a new function, all screws (6) must be turned back to
their horizontal basic position (6).
To transfer a key function:
• Turn all screws to their basic position (6) so that the slots are horizon-
• Turn the screw under the desired key 90° so that the slot is vertical (7).
Operating manual H867 Version 00.0 - Last updated: 01/2012
o
tal.
q w e r t
+/–
+/–
y
u
i
27
Advertisement
Table of Contents
