Table of Contents
Advertisement
Set-up instructions
8.15.3 Lubrication
All wicks and felt bits of the upper section are soaked in oil on delivery.
This oil is conveyed to the reservoir during use, which is why you should
avoid filling too much oil during initial filling.
Figure 50: Oil level indicator
• Pour oil in through the refill opening (1) up to no more than 2 mm
.
Oil to be used:
Only DA 10 or an oil of equivalent quality may be used for the machine,
which has the following properties:
• Viscosity at 40° C: 10 mm²/s
• Flash point: 150° C
Operating manual H867 Version 00.0 - Last updated: 01/2012
WARNING
Skin injuries due to contact with oil.
Oil can cause a rash if it comes into contact with
the skin.
Avoid any skin contact with the oil.
If oil gets on your skin, wash the affected skin
areas thoroughly.
MAX
MIN
below the maximum level marking (2)
ATTENTION
Machine damage possible due to incorrect oil level.
Too little or too much oil can cause damage to the machine.
During initial filling, only pour in oil up to 2 mm below the maximum
level marking.
ATTENTION
Machine damage possible due to incorrect oil.
An incorrect oil type can cause damage to the machine.
Only use oil that complies with the data in the operating manual.
(
1) - Refill opening
q
(2) - Maximum level marking
w
(3) - Minimum level marking
e
45
Advertisement
Table of Contents
