Table of Contents
Advertisement
Operating instructions
(1) - 1. thread guide
(2) - Looper thread guide
(3) - Bobbin winder
Figure 9: Winding on the looper thread - part 1
• Insert the thread from the rear to the front through the right hole in the
• Insert the thread in a wavelike manner through the 3 holes of the
• Guide the thread clockwise around the looper thread winding
• Insert the thread in a wavelike manner through the 2 holes of the
• Guide the thread to the winding bobbin (3).
e
Figure 10: Winding on the looper thread - part 2
• Clamp the thread behind the cutter (1) and tear off the loose end
• Fit the bobbin on the winder (2).
• Turn the bobbin clockwise until it clicks.
• Pull the bobbin lever (3) up.
The looper thread is normally wound on when sewing is in progress. How-
ever, you can also wind on the looper thread without sewing material,
e.g. if you require a full bobbin in order to start sewing.
Operating manual H867 Version 00.0 - Last updated: 01/2012
t
r
1 2 3 4
1st thread guide (1).
2nd thread guide (5): from top to bottom through the left hole, from
bottom to top through the hole in the middle and finally from top to bot-
tom through the right hole.
tensioner (4).
looper thread guide (2): from bottom to top through the left hole and
from top to bottom through the right hole.
behind it.
9
6
2
4
5
1
(4) - Looper thread winding tension
(5) - 2. thread guide
(1) - Cutter
q
(2) - Winder
(3) - Bobbin lever
w
q
w
e
17
Advertisement
Table of Contents
