Table of Contents
Advertisement
4
5
6
7
0,4
11
3
1
1
2
3
4
5
1
5
4
2
3
9
6
205
o
7
All manuals and user guides at all-guides.com
10
2
9
1
8
9
10
10
8
3.1.7
Setting the regulation of the hook lubrication
By turning the lubricating tube (1) in the sense of the arrow
(2), the size of the contacting surface between the wick (3)
and the felt insert (4) is regulated. In this way, the speed of the
capillary lift of oil into the felt insert (5) is influenced, from
which oil is wiped on the surface (6) and is driven by centrifugal
force into the hook path (7).
Setting of full lubrication
- Turn the screw (8) into the position (9).
Setting of limited lubrication
- Turn the screw (8) into the position (10).
After having ended the regulation, set the height of the
lubricating
tube (1) at 0.4 mm from the eccentric (11).
3.1.8 Replacement of the hook
Caution! Danger of injury!
Switch off the main switch ! Before starting the
setting operation, weit until the motor stops!
- Remove the throat plate and the trimming knife.
- Unscrew the screws (1) and remove the gib (2).
- After having suitably turned a bit the hook, remove the
bobbin case (3).
- Unscrew thorougly the screw (4).
- Remove the body of the hook (5) upwards.
- When mounting, the procedure is inverse.
3.1.9
Setting the gear
The mutual angular orientation of the gear wheel (1) relative
to the gear wheel (2) should ensure the accessibility of the
screw (5) at the moment when the hook point comes to lie
opposite the needle (4). The wheel (2) is to be set with its gear
rim symmetrically to the centre of the gear wheel (1). The
clearance between the gear wheels is to be the least possible.
Caution ! Danger of injury!
Switch off the main switch! Before starting the
setting operation, wait until the motor stops!
- Set the angle of 2O5° on the handwheel (6) and lock it with
the screw (7).
- Remove box of the hook (8), according to the paragraph
3.1.10, the hook point (3) is to be turned a bit according to
the illustration.
- Turn the gear wheel (2) into the suitable position and insert
the box of the hook into the machine. Check up, whether
the screw (5) is accessible and, if not, repeat the procedure.
- Set the the distance of the hook from the needle according
to the paragraph 3.1.3.
- Set the precise angular displacement of the hook according
to the paragraph 3.1.4.
- The screws (10) tighten slightly.
- Set the clearence in the gear in turning the screws (9). Check
up, whether the gear has a clearance during the whole
revolution of the hook. Turn the handwheel step by step by
15° and, with each step, grasp the hook and try, if there is an
angular dead travel. Tighten carefully the screws (9).
- Tighten duly the screws (10) and try anew the clearance of
the gear.
4
Advertisement
Table of Contents
