Crown DCi 8 Operation Manual page 22

Software System Configuration
Low-Z (8, 4 or 2 Ohm) Output Operation
Typical input and output wiring, along with Audio Architect
software settings are shown in Figures 20 and 21.
INPUTS: Connect the input with wiring in place for each
channel. If the same signal is to drive both outputs of a
channel pair ("mono"), the input signal can be sent to
adjacent amplifier channels.
OUTPUTS: Maintain proper polarity (+/–) on output
connectors. Connect the Channel 1 speaker's positive (+)
lead to amplifier Channel 1 positive terminal;
repeat for negative (–). Repeat Channel 2 wiring as for
Channel 1, and for any subsequent channel pairs on
multichannel models. Refer to Page 8
for output connector terminal assignments.
Figure 21 Amplifier is preconfigured for Low-Z, Dual Output.
Always route the input and output wires in separate bundles.
page 22
DriveCore Install Network Display Series Power Amplifiers
Figure 20 System Wiring Dual Mode
Operation Manual