Crown DCi 8 Operation Manual page 21

DriveCore Install Network Display Series Power Amplifiers
Software System Configuration
Bridge Mono Operation
The DCi Network Display Series amplifier outputs can be bridged to increase the power and voltage available at the output of the amplifier. The amplifier can be bridged in
the Amplifier Mode window. By selecting the bridging option, only the first input channel will need to be wired. (See Figure 18). Low-Z and High-Z options are still available.
NOTE: If the amplifier output is in bridge mono and the High-Z option is selected, the amplifier will produce 140Vrms or 200Vrms.
Figure 18 Check the Bridge Mono 1+2 box to bridge the output of the amplifiers.
Figure 19 By selecting Mono Bridge output, only one channel in the channel pair DSP will be available.
Operation Manual page 21