Table of Contents
Advertisement
DriveCore Install Network Display Series Power Amplifiers
Software System Configuration
Amplifier Mode Settings
Figure 14 (above) shows the DriveCore Install 2 channel configuration page. The 4 and 8 channel amplifier configuration pages have the same feature set.
The DriveCore Install Network amplifier includes Digital Signal Processing (DSP), multiple input/output routing options and a comprehensive diagnostics feature set.
All of these features can be adjusted in from the configuration page.
The DCi Network Display Series amplifiers are very capable and flexible amplifiers. In the Amplifier Mode Setting window, the following items can be adjusted:
• Hi-Z/Low-Z on an individual channel basis
• 70Vrms or 100Vrms operation
• Any analog input can be sent to any amplifier output
• Mono Bridge Output - Output pairs can be bridged for mono operation
Hi-Z/Low-Z
The DriveCore Install Network amplifiers are capable of High-Z and Low-Z outputs. Each individual channel is capable of Hi-Z or Low-Z operation. To select Hi-Z or Low-Z
operation, double click on the mode button, the Amplifier Mode Setting Window will open (see Figure 15). Note: Choosing 70Vrms or 100Vrms is an amplifier global
setting, and affects all output channels selected for High-Z operation.
Figure 15
Operation Manual
Global
Channel
Specific
page 19
Advertisement
Table of Contents
