Ink Tank Is Empty; Printer Error - Canon Pixma iP90 User Manual

Printer cover open
Close the Print Head Cover.
No Print Head
No Print Head is installed or the Print Head is defective (The POWER lamp on the printer flashes five
times).
Install a Print Head according to your setup guide. If a Print Head has already been installed, remove it, and
then reinstall it.
If the problem still remains, the Print Head may be defective. Contact a Canon service representative.
Waste tank (waste ink absorber
The waste ink absorber is nearly full.
*1
Selecting Continue
while, but printing cannot be continued when the waste ink absorber becomes full. Canon recommends to
contact a Canon service representative as soon as possible.

Ink tank is empty

Printing resumes once the Print Head Cover is closed after an ink tank replacement.
You can continue printing by selecting Continue
But, it is recommended you replace it with a new one immediately after printing. It may damage the printer if
you continue printing with empty ink tanks.

Printer error

The optional battery level is low (The POWER lamp on the printer flashes twelve times).
Follow the procedure below to secure the power supplies.
(1) Turn off the printer.
(2) Connect the supplied Universal AC Adapter or load a charged battery.
(3) Turn on the printer.
An error requiring servicing has occurred (The POWER lamp on the printer flashes alternately orange
and green).
Select Cancel in the Error screen on the camera to cancel the print job.
Disconnect the cable connected to the camera, turn off the printer, and unplug the power cord of the printer
from the outlet. Leave the printer for a while, plug the power cord of the printer back in the outlet, turn on
the printer, and connect the camera to the printer. If the error persists, contact a Canon service
representative.
*1 You can press the RESUME/CANCEL button on the printer instead of selecting Continue.
*2 Ink used for cleaning is absorbed in the waste ink absorber placed in the printer. If this error occurs,
replacement of the waste ink absorber and maintenance of the printer are required.
*2
in the Error screen on the camera resumes printing. Printing can be continued for a
) full
*1
in the display on your camera with the ink tank empty.