Setting Up The Monitor; Installing The Stand (Sold Separately) - HP LD4200 User Manual

3

Setting Up the Monitor

To set up the monitor, ensure that the power is turned off to the monitor, computer system, and other
attached devices, then follow the instructions below.

Installing the Stand (Sold Separately)

1. Remove the screws (1), monitor stand (2) and cable management clip (3) from the box.
NOTE:
26mm screws.
Figure 3-1
Figure 3-2
4 Chapter 3 Setting Up the Monitor
The LD4200 stand uses six M4 x 12mm screws. The LD4700 stand uses four M4 x
LD4200 Stand Accessory Contents
LD4700 Stand Accessory Contents
ENWW