Complete Installation; Range Hood Use; Range Hood Controls - Whirlpool LI3YRB Installation Instructions And Use & Care Manual

1. For non-vented (recirculating) installations only, install
charcoal filters over grille on blower housing. See the "Range
Hood Care" section.
2. Install metal filters. See the "Range Hood Care" section.
The range hood is designed to remove smoke, cooking vapors
and odors from the cooktop area. For best results, start the hood
before cooking and allow it to operate several minutes after the
cooking is complete to clear all smoke and odors from the
kitchen.
The hood controls are located on the front side of the canopy.
A
E
G
A. Duct cover holes
B. Duct cover
C. Control panel
D. Glass canopy
10

Complete Installation

RANGE HOOD USE

B
C
E
F
E. Halogen lamps
F. Grease filter
G. Grease filter release handle
3. Check the operation of the range hood blower and light. See
the "Range Hood Use" section.
If range hood does not operate, check to see whether a
circuit breaker has tripped or a household fuse has blown.
NOTE: To get the most efficient use from your new range hood,
read the "Range Hood Use" section.
A
Operating the light
The On/Off light button controls both lights. Press once for On
and again for Off.
D
Operating the blower
The Blower Speed buttons turn the blower on and control the
blower speed and sound level for quiet operation. The speed can
be changed anytime during fan operation by pressing the desired
blower speed button.
The Blower Off button turns the blower Off.

Range Hood Controls

B C D E
A. On/Off light button
B. Blower Off button
C. Blower speed minimum button
D. Blower speed medium button
E. Blower speed maximum button