Riding - DAELIM Roadwin 250R Fi Owner's Manual

RIDING

1. After the engine has been warmed up,
the motorcycle is ready for riding.
2. While the engine is idling, pull in the
clutch lever and depress the gearshift
pedal to shift into 1st (low) gear.
3. Slowly release the clutch lever and at
the same time gradually increase engine
speed by opening the throttle. Coor-
dination of the throttle and clutch lever
will assure a smooth positive start.
4. When the motorcycle attains a mode-
rate speed, close the throttle, pull in the
clutch lever and shift to 2nd gear by
raising the gearshift pedal.
This sequence is repeated to progre-
ssively shift to 3rd, 4th, 5th (top) gear.
5. Coordinate the throttle and brakes for
smooth deceleration.
6. Both front and rear brakes should be
used at the same time and should not be
applied strongly enough to lock the
wheel, or braking effectiveness will be
reduced and control of the motorcycle
be difficult.
<GEAR DOWN OPERATION>
If you gear down when you need to
drastically accelerate speed such as when
you are passing another motorcycle, speed
can be accelerated. If you ride too fast, it
adversely affects engine because engine
revolution is excessive.
2 3
4 5
1
CAUTION
Touch pedal lightly with foot and
●
shift gear perfectly until you hear
"Click" at the pedal. If you apply
excessive force when shifting gear,
transmission may be damaged.
NOTE
Make sure side stand is in original
●
position prior to starting motorcycle.
If side stand moves unsatisfactorily,
check lubrication state on side stand
joint.
Shift gear adequately according to
●
vehicle speed.
To save fuel and maintain optimum
●
vehicle life, do not accelerate or
decelerate speed abruptly.
Always start in the 1" gear, and start
●
carefully as slow as possible.
If you hear abnormal noise during
●
travel, contact authorized main-
tenance shop immediately for
inspection and necessary action.
Maintain legal speed limits.
●
29