Inserting/Exchanging Rotating Gobos - Elation COLOR SPOT 150 User Manual

To reduce a hot-spot, pull the lamp in by turning all three screws „A, B, C" clockwise 1/4-turn at a time until the
light is evenly distributed.
If the light is brighter around the edge than it is in the center, or if light output is low, the lamp is too far back in the
reflector. „Push" the lamp out by turning the screws „A, B, C" counterclockwise 1/4-turn at a time the light is bright
and evenly distributed.

4.3 Inserting/Exchanging rotating gobos

DANGER!
Install the gobos with the device switched off only.
Unplug from mains before!
To insert the gobos open the top cover of the head by loosening the 2 screws .
If you wish to use other forms and patterns as the standard-gobos, or if gobos are to be exchanged,remove the
fixation-ring with an appropriate tool. Remove the gobo and insert the new gobo. Press the fixation-ring together
and insert it in front of the gobo.
gobo fixation-ring
CAUTION!
Never unscrew the screws of the rotating gobo
as the ball bearing will otherwise be opened!
7