Lenovo ThinkServer 1045 Installation And User Manual page 85

Table 15. Submenus under the Mass Storage Controller Configuration
Item
SATA Configuration
Configure SATA as
Notes:
1. The settings in [ ] are the default settings in the Setup Utility program.
2. The SATA Configuration item might not apply because your server came with an integrated SAS controller.
Table 16. Submenus under the SuperIO Configuration
Item
Serial Port1 Address
Serial Port2 Address
Note: The settings in [ ] are the default settings in the Setup Utility program.
Table 17. Submenus under the USB Configuration
Item
Legacy USB Support
USB 2.0 Controller Mode
Hotplug USB FDD Support
Note: The settings in [ ] are the default settings in the Setup Utility program.
For external USB devices, the USB Mass Storage Device Configuration submenu is as below:
Emulation Type
Option
Disabled / [Enabled]
[IDE] / RAID
Option
Disabled; [3F8/IRQ4]; 3E8/IRQ4;
2E8/IRQ3
Disabled; [2F8/IRQ3]; 3E8/IRQ4;
2E8/IRQ3
Option
Disabled / [Enabled] / Auto
FullSpeed / [HiSpeed]
Disabled / Enabled / [Auto]
[Auto] / Floppy / Forced FDD / Hard
Disk / CDROM
Description
Enable or disable the integrated SATA
controller.
To select the hard disk drive mode.
If this option is set to IDE, all the
SATA connectors will be configured
as stand-alone SATA connectors.
Description
Select the I/O base address and
interrupt for serial port 1.
Select the I/O base address and
interrupt for serial port 2.
Description
Enable or disable the support on
legacy USB devices.
Select the USB speed.
Enable or disable the support on the
hot-swap USB diskette drive.
Select the type of the USB device.
.
Chapter 6 Configuring the server
75