c. Hold the battery card assembly with the battery side up and the J2 board-to-board connector lining
up with the J7 BBU connector
1
on the RAID controller. Carefully press the battery card assembly
onto the RAID controller so that the two connectors are firmly joined. Then, secure the battery
card assembly to the RAID controller with the three screws and the standoffs that come with the
battery card assembly accessory kit.
Figure 34. Installing the battery card assembly
1
J7 BBU connector
5. See "Installing a PCI card" on page 37 and follow those instructions to install the RAID controller.
44
ThinkServer Installation and User Guide