Lenovo ThinkServer 1045 Installation And User Manual page 45

4. Loosen the retaining screws on the front and rear of the riser card assembly. Then, remove the riser
card assembly from the server.
Note: If the riser card is secured in place by a retaining latch
the riser card from the latch. Then, carefully pull the riser card assembly out of the slot. If necessary,
alternate moving each side of the riser card a small and equal amount until it is completely removed
from the slot.
Figure 26. Removing the riser card assembly
What to do next:
• To work with another piece of hardware, go to the appropriate section.
• To complete the removal procedure, go to "Completing the parts replacement" on page 68.
Installing the riser card assembly
Attention: Do not open your server or attempt any repair before reading and understanding the "Safety information"
on page iii and "Guidelines" on page 17.
1 , press the retaining latch to release
.
Chapter 5 Installing, removing, or replacing hardware
35