Planet GSW-1602SF User Manual page 113

Reauthentication
This select field allows the user to enable or disable reauthentication of the supplicant for the
Enabled
specified port. If "Enabled" be checked, reauthentication will occur. Otherwise, reauthentication
will not be allowed. Changing the selection will not change the configuration until the Apply
button is pressed.
The default value is not "Enabled" .
Reauthentication
This input field allows the user to enter the reauthentication period for the selected port. The
Period
reauthentication period is the value, in seconds, of the timer used by the authenticator state
[1-3600 seconds]
machine on this port to determine when reauthentication of the supplicant takes place. The
reauthentication period must be a value in the range of 1 and 65535. Changing the value will not
change the configuration until the Apply button is pressed.
The default value is 3600.
EAP Timeout
This input field allows the user to enter the EAP timeout for the selected port. The EAP timeout is
[1-255 seconds]
the value, in seconds, of the timer used by the authenticator state machine on this port to timeout
the supplicant. The EAP timeout must be a value in the range of 1 and 255.
The default value is 30.
Button
Press this button for save current configuration of Web Smart Gigabit Switch.
Apply
Press this button for refresh 802.1X System Configuration screen of Web Smart Gigabit Switch.
Refresh
Setup the RADIUS server and assign the client IP address to the Web Smart Gigabit Switch. In this case, field in the default
IP Address of the Web Smart Gigabit Switch with 192.168.0.100. And also make sure the shared secret key is as same as
the one you had set at the switch RADIUS server – 12345678 at this case.
Table 4-29 Description of the 802.1X Configuration
Figure 4-76 RADIUS Server configuration
-107-
User's Manual of GSW-1602SF / GSW-2404SF