LED signal
Security
Handset name Change the name the handset displays on the standby screen.
Reset settings
Status
Auto answer
Silent charging
Do not disturb Turn on the Do Not Disturb feature.
Audio Screen
Change the ringer tone and volume.
Ring volume
Ring melody
Alert volume
Configure what color the Status LED turns when you miss a call, have a
new voice message, or need to recharge the battery.
Set handset security features.
Reset all the options on this handset to factory default values.
The status screen displays the following information (you will have to
scroll down to see all the fields):
The IP address, MAC address, and system name of the base this
handset is registered to.
The hardware version and software version of the base this handset is
registered to.
The hardware version and the software version of this handset.
The current band DECT radio band the handset is operating in.
The handset's battery level.
The handset's IPEI.
Choose how you want the handset to answer incoming calls:
Normal (default): you must press Talk to answer calls.
Any key: you can press any key to answer calls.
Automatic: the handset answers all calls after 5 seconds.
Choose how the handset responds to incoming calls while it is charging:
Off: The handset rings normally and displays the incoming call screen.
Disconnected: The handset does not respond to incoming calls at all.
Silent: The handset does not ring, but it does display the incoming call
screen.
Set the ringer volume. Press Up to raise the volume and Down to lower
the volume. Press Select or
setting.
Choose this handset's ring melody. As you highlight each ring melody,
press
Play
to hear a sample. When you hear the melody you want, press
Select.
Set the volume for notification tones. Press Up to raise the volume and
Down to lower the volume. Press Select or
with the volume setting.
OK
when you're satisfied with the volume
OK
when you're satisfied
Need help?
Do you have a question about the IP4100 SIP DECT and is the answer not in the manual?