Zanussi ZWI 71201 WA User Manual page 14

Measure out the detergent and the fabric
softener
Pull out the dispenser drawer until it stops.
Measure out the amount of detergent re-
quired, pour it into the main wash compart-
ment or in the appropriate compartment if
the selected programme/option it requires
(see more details in "Detergent dispenser
drawer").
If required, pour fabric softener into the com-
partment marked
not exceed the «MAX» mark in the drawer).
Close the drawer gently.
Select the required programme by means
of the programme selector dial (1)
Turn the programme selector dial to the re-
quired programme.
The green pilot light of button 7 starts to flash.
The selector dial can be turned either clockwise
or anticlockwise.
Turn the selector dial to position
programme/to switch the machine OFF.
At the end of the programme the selector
dial must be turned to position
switch the machine off.
Important! If you turn the programme selector
dial to another programme when the machine is
working, the red pilot light of button 7 will blink
3 times and the messageErr is displayed to
indicate a wrong selection. The machine will not
perform the new selected programme.
Select the spin speed by pressing button 2
When selecting a programme, the appliance
proposes automatically the maximum spin
speed provided for that programme. (See
"Washing programmes" for the maximum al-
lowed spin speed).
14
(the amount used must
to reset the
, to
Press this button repeatedly to change the spin
speed, if you want your laundry to be spun at a
different speed. The relevant pilot light illumi-
nates.
Select the available options by means of
buttons 3, 4, 5 and 6
Depending on the programme, different options
can be combined. These must be selected after
choosing the desired programme and before
starting the programme. When these buttons
are pressed, the corresponding pilot lights illu-
minate. When they are pressed again, the pilot
lights go out. If an incorrect option is selected,
the integrated red pilot light of the button 7
flashes 3 times and the message Err is dis-
played.
For the compatibility among the washing pro-
grammes and the options see chapter «Wash-
ing programmes».
Start the programme by pressing button 7
To start the selected programme, press this
button; the corresponding green pilot light
stops blinking.
The pilot light 9 illuminates to indicate that the
appliance starts operating and the door is
locked.
If you have chosen a delayed start, the machine
will begin the countdown.
Important! If an incorrect option is selected,
the message Err is displayed for a few seconds
and the red pilot light of this button blinks 3
times.
Select the Delay Start by pressing button
8
Before you start the programme, if you wish to
delay the start, press this button to select the
desired delay.
The selected delay time value will appear on the
display for a few seconds, then the duration of
the programme will appear again.
You must select this option after you have set
the programme and before you start the pro-
gramme.
You can cancel or modify the delay time at any
moment, before you press button 7.
Selecting the delay start :
www.zanussi.com