Table of Contents
Advertisement
Code
Function Code Name
F28
Film Leader
F29
Advance Film to End of
Roll
F30
Display Film Remaining
F31
Lead End Code
F32
Trail End Code
F33
Roll Number
F34
Operator ID Number
F35
Cassette ID Number
F37
Calibration
F38
End-of-Job
F39
Printer Character Shift
(for Document Printers)
F39
Print Contrast
(for Super12 Document
Printer)
A-61096 June 1999
Allows you to create a film leader which is 6 feet (1.8
meters) of blank film.
Allows you to advance the film to the end of the roll. Use
F29 prior to unloading a film cassette. A low film warning
will be displayed after the film has been advanced.
Allows you to display the amount of film remaining (in
inches or meters) in each film cassette. It also displays
the approximate number of documents which can be
filmed using the remaining amount of film. Press C to
return to a normal operating display.
Allows you to create a lead end code for retrieval
purposes. Enter the following values.
•
Roll number
•
Operator ID
•
Next Image Address
Press Enter after each value is entered.
Allows you to create a trail end code for retrieval
purposes. Trail end code is only used when using Duo
mode.
Allows you to display the current roll number or change to
a new roll number. To enter a new roll number, enter the
desired roll number and press Enter.
Allows you to display the operator ID number or change
to a new operator ID number. Enter a new operator ID
(up to 3 digits) and press Enter.
Allows you to display or change the cassette ID number.
Enter a new cassette ID number (up to 2 digits) and
press Enter.
Allows you to initiate the calibration process required
before scanning documents. To do this, feed a calibration
target into the scanner/microimager.
Allows you to signal the host computer that the last
document of the job has been fed into the transport.
Allows you to select which set of ink jets will be used to
print each character. Enter 1 to select the left set of ink
jets, enter 2 to select the center set of ink jets, or enter 3
to select the right set of ink jets, then press Enter.
Allows you to increase or decrease the amount of ink put
on the document. Press the Up arrow for more ink and
press the Down arrow for less ink. Incremental values
are: 12, 25, 37, 50, 62, 75, 87 and 100%.
Description
4-7
Advertisement
Table of Contents
