Table of Contents
Advertisement
Using the Check Feeder / Check Stacker
Using the check
feeder
A-61096 June 1999
The check feeder/check stacker provides continuous feeding of small-
sized documents; such as checks.
NOTE: The check feeder can only be used on a 990S
Scanner/Microimager and will not work on the Kodak Digital
Science Document Scanner/Microimager 990D without a
special alteration. See your Value Added Reseller for more
information.
To use the check feeder, follow the procedures below:
NOTE: Thick documents may be processed with the check feeder
installed by using the hand-feed throat with the gap release
lever held down.
Adjust the feeder left-side guide to accommodate the width of the
documents.
1. Turn on the side panel switch.
2. Adjust the feed and separator rollers for the thickness of the
documents.
3. Properly prepare the documents, removing any staples, rubber
bands, paper clips, or loose mending tape. Straighten any wrinkled
edges and torn documents.
4. Make sure the documents are evenly stacked, with the leading and
left edges square, for proper feeding and endorsement positioning (if
documents are to be endorsed).
5. Place the documents against the check guide.
6. Press Run to feed the documents.
8-23
Advertisement
Table of Contents
