Maintenance Button - Kodak Ngenuity 9000 Series User Manual

Maintenance button

3-14
When you click the Maintenance button on the Ngenuity Operator
Utility main screen, the Maintenance screen will be displayed.
This screen provides scanner statistics for total hours, total pages fed
and total pages scanned. The Maintenance screen also allows you to
configure reminders for different maintenance tasks that are required to
ensure optimal performance.
Scanner Stats — this area provides statistics for Total On Time
(awake and sleeping), Total Pages (fed) and total Scanned Pages.
These totals are updated every 2 seconds.
Configuration Maintenance Reminders — allows you to set the
interval values for triggering the reminders that are visible in the
Maintenance section of the Home screen.
Intervals can be set for cleaning the feed rollers (skimmer rollers: pick
and drive and separator roller), the transport rollers, the optics and to
replace the feed rollers (skimmer rollers and separator roller). These
reminders can also be individually enabled and disabled. It is
recommended that you do not disable any of these reminders.
To enable and adjust a maintenance reminder, click the check box next
to the corresponding component and use the up/down arrows in the
Page Interval column to change the value. Click Save to save your
changes or Restore to reset the values to the previously saved
settings.
The available interval settings and their defaults are:
Reminder
Clean Feed Rollers (skimmer rollers and separator roller)
Clean Transport Rollers
Clean Optics (camera covers, imaging guides, sensors)
Replace Feed Rollers (skimmer rollers and separator roller)
Range Default
1K - 50K 10K
5K - 100K 50K
5K - 150K 50K
100K - 900K 600K
A-61662 April 2010