Keyboard And Mouse - HP Model 743 PC Owner's Manual

NOTE:

Keyboard and Mouse

This section provides step-by-step instructions for connecting a keyboard
and mouse to your Model 743.
1 Unpack your new keyboard and place it near your board computer.
2 Plug the keyboard cable connector into your board computer at the PS/2
connector labeled PS/2 0 Kbd.
The keyboard must be connected to PS/2 0 to be operational.
3 Unpack your new mouse and locate the mouse's black rubber ball in the
mouse box.
4 Remove the ball plate from the bottom of the mouse. Insert the ball and
replace the ball plate.
5 Plug the mouse cable connector into your board computer at the PS/2 con-
nector which is labelled PS/2 1.
Typical Installation in a VME Card Cage
Keyboard and Mouse
3-5