Table 3-3
3-6
Typical Installation in a VME Card Cage
Board Computer Installation
Board Computer Installation
Tools Required
Installing the board computer requires the following tools:
Required Tools for Installation
Tool
Grounding wrist strap
(supplied with the installation kit)
No. 1 Pozidriv screwdriver
3
5 mm (
/
-inch) nutdriver
16
Light-duty flat-tipped screwdriver
Preliminary Requirements
Before you install the board computer into the VMEbus card cage, read the
steps in "Configuring the VMEbus Card Cage," earlier in this chapter.
Installing a Single VME Slot 743 into an HP Card Cage
Follow these steps to install the board computer into the VME card cage:
1 Position the board computer at the desired slot and slide it into the card
cage until it seats properly and the Front Panel is flush against the card
cage.
2 Push both ejector levers in until they are flush with the front panel.
3 Engage and tighten the captive screws (labeled 1 and 2 in Figure 3-1) at
each end of the board computer. These screws hold the computer in the
VME card cage.
Used For
Preventing static discharge problems
Attaching accessory cards
Attaching accessory cards
Attaching accessory cards