Memory; Preliminary Requirements; Ram Card Installation - HP Model 743 PC Owner's Manual

Memory

This section provides step-by-step instructions for installing RAM cards in
your Model 743.

Preliminary Requirements

Perform the following steps before you install a RAM card in your
Model 743:
1 If the Model 743 is already installed in your system card cage, you must
remove it. See Chapter 3 of this book for instructions on removing and re-
placing the Model 743.
2 Place the Model 743 on a static free mat on a clean, level surface.

RAM Card Installation

You do not need to follow any particular card order when installing RAM
cards into your Model 743. Use these steps to install the RAM cards:
1 Place the first RAM card on the board standoffs, lining up the connector
on the RAM card with the connector on the board, as shown in Figure 2-1.
2 Gently press to seat the RAM card in the connector.
3 To stack RAM cards, install standoffs between each card, ending with re-
taining screws on the top RAM card. If you install single RAM cards in
either the left or right locations, the retaining screws go into the board
standoffs.
Accessories Installation
Memory
2-5