Connection Guide - Swann ADW-200 Operating Instructions Manual

Connection Guide

1. Attach the antenna to the rear of the camera.
2. Connect the supplied power adapter (5V) to the power input on the camera.
3. Plug the power adapter in to a wall socket.
4. Attach the antenna to the receiver.
5. Connect the supplied power adaptor to the power input on the rear of the
receiver.
6. Connect the supplied A/V cable to the A/V OUT port on the rear of the receiver
(the plug looks like a miniature headphone jack).
7. Connect the yellow VIDEO OUT plug to the VIDEO IN port (usually also yellow)
on your VCR/DVD recorder.
8. If you want to monitor/record audio, then plug the white AUDIO OUT plug
into the AUDIO IN port (also typically white) on the VCR/DVD recorder.
9. Connect the Video/Audio OUT of the VCR/DVD recorder to a TV as detailed
below.
10. Attach the yellow VIDEO OUT plug to one of the INPUTS on the rear of the
DVR. If your DVR uses BNC connectors, you'll need to use a BNC/RCA adaptor
(as pictured in the diagram). Most DVRs use BNC plugs.
11. If DVR supports audio, then you can plug the white AUDIO OUT plug to an
AUDIO INPUT on the rear of the DVR. These typically use RCA plugs and won't
need an adaptor - but exceptions to this rule exist.
12. Connect the AUDIO and VIDEO OUTPUTS to your TV. Consult your DVR's
manual for more information regarding connecting a monitor to your DVR.
13. Connect the yellow VIDEO OUT plug to a VIDEO IN port (usually yellow as well)
on the TV you want to use. Avoid component inputs (which are color coded
red, green and blue) as these use a very different type of video signal.
14. If you want to monitor audio, the connect the white AUDIO OUT plug to an
AUDIO INPUT on the TV.
6 6 6
1
Connecting the Camera
Connecting the Receiver
Connecting to a VCR / DVD Recorder
Connecting to a DVR
Connecting directly to a TV
2
3