Connecting Wires To Terminals - Kenwood DDX7025BT Instruction Manual

CONNECTION/INSTALLATION
Connection
❏ Connecting wires to terminals
Page 57
USB terminal:
Pages 56 – 57
Connect the aerial cord
to the aerial terminal.
1
Blue with white stripe (Power control/aerial control wire)
Brown (Mute control wire)
Light blue with yellow stripe (Steering remote control wire)
Orange with white stripe (Dimmer control wire)
Yellow (Battery wire)
Red (Ignition wire)
Red (A7)
Yellow (A4)
Connector A
Connector B
Pages 56 – 57
REVERSE
Page 58
Connecting the ISO connectors on some VW/
Audi or Opel (Vauxhall) automobiles
You may need to modify the wiring of the
supplied wiring harness as illustrated below.
Red
(Ignition wire)
Unit
Yellow
(Battery wire)
Default wiring
Purple with white stripe
(Reverse sensor wire)
PRK SW
Light green
(Parking sensor wire)
10 A fuse
* If no connections are made, do not let the cable come
out from the tab.
To the power control terminal when using the optional power amplifier or to
*
the aerial control terminal in the vehicle.
To the terminal that is grounded when either the telephone rings or during
conversation. (To connect the Kenwood navigation system, consult your
navigation manual.)
To use the steering wheel remote control feature, you need an exclusive
remote adapter (not supplied) matching your car is required.
To car light control switch
Pin Color and functions of Connector A and B
A4 Yellow
A5 Blue/White
A6 Orange/White
A7 Red
Red (A7)
A8 Black
Vehicle
B1/B2 Purple ª / Purple/Black ·
B3/B4 Gray ª / Gray/Black ·
Yellow (A4)
B5/B6 White ª / White/Black ·
B7/B8 Green ª / Green/Black ·
Connect to the vehicle's reverse lamp harness when
using the optional rear view camera.
Connect to the vehicle's parking
brake detection switch harness.
3
• For best safety, be sure to
connect the parking sensor.
Battery
Power control
Dimmer
Ignition (ACC)
Ground connection
Right speaker (rear)
Right speaker (front)
Left speaker (front)
Left speaker (rear)
ENGLISH 55