Partner K3000 EL Operator's Manual page 14

Checking the drive shaft and flanges
Check that the threads on the drive shaft are undamaged.
Check that the contact surfaces of the cutting blade and
flanges are flat, run correctly on the spindle and are free from
foreign objects.
Do not use flanges that are twisted, have damaged edges,
untrue or dirty. Do not use different size flanges..
Below you will find some general maintenance
instructions.
Daily maintenance
1 Check that nuts and screws are tight.
2 Check that the power switch unit works smoothly.
3 Clean the outside of the machine.
4 Inspection of the guard for the cutting blade
5 Check the condition of the cutting blade.
6 Check and clean the cooling air openings
7 Check that the cord and extension cord are intact and in
good condition.
´®z*xyh¶6R¨
´®z*xyh¶6R¨
14 –
English
MAINTENANCE