Daikin FTXS80KVMA Operation Manual page 14

■ To start 3-D airflow
1. 3. Press the "SWING button
the " " and "
move in turn.
■ To cancel 3-D airflow
2. 4. Press either the "SWING button
■ COMFORT AIRFLOW operation
• Check COMFORT AIRFLOW operation in the section of "COMFORT AIRFLOW Operation" and
"INTELLIGENT EYE Operation". (page 14, 15.)
Notes on flaps and louvers angles
• When "SWING button" is selected, the flaps
swinging range depends on the operation mode.
(See the figure.)
Three-Dimensional (3-D) airflow
• Using three-dimensional airflow circulates cold
air, which tends to collected at the bottom of the
room, and hot air, which tends to collect near the
ceiling, throughout the room, preventing areas of
cold and hot developing.
■ ATTENTION
• Always use a remote controller to adjust the
angles of the flaps and louvers. If you attempt to
move the flaps and louvers forcibly with hand
when they are swinging, the mechanism may be
broken.
• Always use a remote controller to adjust the
louvers angles. In side the air outlet, a fan is
rotating at a high speed.
" and the "SWING button
" display will light up and the flap and louvers will
" or the "SWING button
COOL and DRY mode
Stop
operation
COMFORT
AIRFLOW (40˚)
Upper
limit (45˚)
Lower limit (80˚)
HEAT mode
Stop
operation
Upper limit (60˚)
Lower limit (100˚)
FAN mode
Stop
operation
Upper limit (45˚)
Lower limit (100˚)
":
".
COMFORT
AIRFLOW (105˚)
13