Makita 3707F Instruction Manual page 9

1
2
3
4
5
6
1. Bolt
2. Guide plate
3. Straight guide
4. Flat washer
5. Wave washer
6. Wing nut
1
2
3
1. Clamp screw (A)
2. Straight guide
3. Wing nut
4. Base
A
Straight guide (optional accessory)
001989
The straight guide is effectively used for straight cuts when
chamfering or grooving.
Attach the guide plate to the straight guide with the bolt, the
001990
wave washer, the flat washer and the wing nut.
Attach the straight guide with the clamp screw (A). Loosen
001991
the wing nut on the straight guide and adjust the distance
between the bit and the straight guide. At the desired dis-
tance, tighten the wing nut securely.
When cutting, move the tool with the straight guide flush with
the side of the workpiece.
4
If the distance (A) between the side of the workpiece and the
001992
cutting position is too wide for the straight guide, or if the side
of the workpiece is not straight, the straight guide cannot be
used. In this case, firmly clamp a straight board to the work-
piece and use it as a guide against the trimmer base. Feed
the tool in the direction of the arrow.
9