Makita 3707F Instruction Manual page 8

2
1
1. Feed direction
2. Bit revolving direction
3. Workpiece
4. Trimmer shoe, straight guide
1
2
1. Screws
2. Base protector
3. Screwdriver
4. Screws
1
2
3
4
10mm(3/8")
1. Straight bit
2. Base
3. Templet
4. Distance (X)
5. Workpiece
6. Templet guide 10
8
• When using the trimmer shoe, the straight guide or the
001985
trimmer guide, be sure to keep it on the right side in the
3
feed direction. This will help to keep it flush with the side
of the workpiece.
CAUTION:
• Since excessive cutting may cause overload of the motor
4
or difficulty in controlling the tool, the depth of cut should
not be more than 3 mm (1/8") at a pass when cutting
grooves. When you wish to cut grooves more than 3 mm
(1/8") deep, make several passes with progressively
deeper bit settings.
Templet guide
001986
The templet guide provides a sleeve through which the bit
passes, allowing use of the trimmer with templet patterns.
Loosen the screws and remove the base protector. Place the
001987
templet guide on the base and replace the base protector.
3
4
Then secure the base protector by tightening the screws.
Secure the templet to the workpiece. Place the tool on the
001988
templet and move the tool with the templet guide sliding
6
along the side of the templet.
NOTE:
• The workpiece will be cut a slightly different size from the
5
templet. Allow for the distance (X) between the router bit
and the outside of the templet guide. The distance (X)
can be calculated by using the following equation:
Distance (X) = (outside diameter of the templet guide - router
bit diameter) / 2