Makita 3707F Instruction Manual page 11

1. Nail
2. Center hole
3. Straight guide
1
2
3
1. Adjusting screw
2. Clamp screw (B)
3. Trimmer guide
4. Clamp screw (A)
1
1. Workpiece
2. Bit
3. Guide roller
Align the center hole in the straight guide with the center of
001995
the circle to be cut. Drive a nail less than 6 mm (1/4") in
1
diameter into the center hole to secure the straight guide.
Pivot the tool around the nail in clockwise direction.
2
3
Trimmer guide
001996
Trimming, curved cuts in veneers for furniture and the like
can be done easily with the trimmer guide. The guide roller
rides the curve and assures a fine cut.
Install the trimmer guide on the tool base with the clamp
001997
screw (A). Loosen the clamp screw (B) and adjust the dis-
4
tance between the bit and the trimmer guide by turning the
adjusting screw (1 mm (3/64") per turn). At the desired dis-
tance, tighten the clamp screw (B) to secure the trimmer
guide in place.
When cutting, move the tool with the guide roller riding the
001998
side of the workpiece.
2
3
11