Getting Started; Assembly; To Assemble The Land Ranger - Bounty Hunter Land Ranger Owner's Manual

Getting Started

Assembly

Assembling your Land Ranger™ is easy and does not require any
tools. Using the following diagram as your guide, just follow these
easy steps.
Knurled
Knob
Bolt

To assemble the Land Ranger™

1. Attach the search coil to the lower stem with knob and bolt supplied.
2. Press the button on the upper end of the lower stem and slide the
lower stem into the upper stem.
3. With your arm relaxed at your side and the search coil level to and
about one inch above the ground, adjust the stem to a length that lets
you maintain a comfortable upright posture.
4. Wind the search coil cable around the stem, leaving enough slack in
the cable to let you adjust the coil when you are hunting on uneven
ground.
TIP:
To adjust the coil, simply loosen the knob.
5. Insert the coil's plug into the matching connector on the control
housing, making sure that the holes and pins line up correctly.
CAUTION:
Do not force the plug or you might damage it.
To disconnect the cable, pull out the plug—do not pull on the
cable.
3
Lower
Stem
Plug
Upper
Stem
Search
Coil
Cable
Lower
Stem
Connector
on back of
control housing
Upper
Stem
Control
Housing