Advertisement
18
Safety cable installation
Safety Cable
Lag Screw
safety
cable
washer
lock
3" lag
washer
screw
For Canadian installation and for USA fan and
light kit combinations over 35 lbs, in both flush
and downrod modes the safety cable must be
installed into the house structure beams using
3" lag screws, washers and lock washers pro-
vided. Make sure that when the safety cable is
fully extended the lead wires are longer than
the cable and no stress is placed on the lead
ires.
Note: If installing it in the U.S., Do Not Remove
Knockouts In The Outlet Box.
21
Loosen one and remove one preassem-
bled screw from mounting bracket. Save
screw. Lift canopy up, aligning its keyhole
slot with the preassembled screw on
mounting bracket and twist clockwise to
lock in place. Re-install the removed
screw and tighten all screws securely.
24
Loosen 2 screws and remove 1 screw
and save.
© 2013 Monte Carlo Fan Company
19
Make wire connections to power source using
wire nuts provided. Make sure that no filiments
are outside of the wirenut. After making the
wire connections, the wires should be spread
apart with the grounded conductor and the
equipment-grounding conductor on one side of
the outlet box and ungrounded conductor on the
other side of the outlet box.
22
Install 3 screws and washers per blade
and tighten securely. Repeat for all 5
blades. (Blades sold separately)
Note: This fan includes 2 sets of 18 blade
screws in 2 different lengths depending
on the thickness of the blade selected for
use with this fan. Please select the length
that best fits the blade thickness.
25
Install the switch housing cover by
aligning the 2 screws with the 2 key
slot holes on the plate and twist to
lock into place. Install the 1 screw re-
moved and tighten the other 2
screws securely.
5
20
Make wiring connections as indicated
above. Connect black and blue wire from
fan to Black or (Hot) wire from house.
Connect White wire from Fan to White
(Neutral) wire from house. Connect
Ground leads from mounting bracket and
downrod to Ground lead from house.
Refer to Safety Tips section of manual.
23
Attach blade assembly to motor using
the motor screws and washers pro-
vided. Tighten screws securely.
26
Remove the 3 screws on the switch
housing cover and save.
7/1/2013
Advertisement
