Table Of Contents - Extron electronics IPL T PC1 Setup Manual

This page was intentionally left blank.

Table of Contents

Chapter One • Introduction
About this Manual
..................................................................... 1-2
About the IPL T PC1
................................................................... 1-2
About Global Configurator
System requirements. . ............................................................ 1-4
Installing Global Configurator............................................... 1-4
Downloading and installing from the Extron Web site . 1 -4
Installing from CD-ROM - Autorun enabled ................ 1-5
Installing from CD-ROM - Autorun not enabled.......... 1-5
Chapter Two • Hardware Setup
Front Panel
. . .................................................................................. 2-2
Rear Panel
..................................................................................... 2-3
Connecting the Hardware
Wiring the Local Area Network (LAN) port. . ......................... 2-5
RS-232 port cabling. . ............................................................... 2-6
Accessing the Communication Sheet. . ............................. 2-6
Connecting to the display device. . ................................... 2-7
Wiring for IR control............................................................... 2-8
Wiring the contact Input port................................................ 2-8
Chapter Three • Software Setup
Creating a Global Configurator Project File
Step One: Download device drivers...................................... 3-2
Step Two: Create a new project.. . .......................................... 3-4
Step Three: Add a device.. . ..................................................... 3-6
Step Four: Define the location of the new device.. . ............. 3-8
Step Five: Save the new Global Configurator file................ 3-9
Step Six: Enter contacts........................................................ 3-10
Step Seven: Create e-mail messages................................... 3-11
Step Eight: Enter output receptacle and contact input
port labels............................................................................. 3-12
Step Nine: Assign device drivers.. . ....................................... 3-13
Assigning a serial driver ................................................ 3-13
Assigning an IR driver . . .................................................. 3-14
Step Ten: Set scheduled actions and e-mail deliveries.. . .... 3-16
Selecting an action. . ........................................................ 3-16
Scheduling e-mail delivery............................................. 3-18
Step Eleven: Set monitored conditions............................... 3-20
. . .................................................. 1-1
..................................................... 1-3
............................................ 2-1
....................................................... 2-4
.......................................... 3-1
. . ..................... 3-2
IPL T PC1 • Table of Contents i