Table of Contents
Advertisement
NOTE
VESA pass-through connector for video boards
3 How to Install Accessories In Your PC
Installing Accessory Boards
7 Secure the board by replacing the slot cover screw.
If you loosened the screws on adjacent slots, tighten them.
8 If you install a VESA-standard video adapter board which uses the
integrated video graphics controller, connect the accessory board's
cable to the VESA pass-through connector on the system board. To
access the VESA pass-through connector, lift the power supply out
of its seating, and lay it upside down on the frame above the disk
drives. Remove the protection cover from the rear base of the PC.
When the 1 MB video memory upgrade is installed on the integrated
video graphics controller, connecting a VESA-standard video adapter
board will disable this additional 1 MB of video memory and only the
first 1 MB of video memory will be used.
Protection cover
9 Install any other accessories before replacing the power supply and
the cover. Reconnect all cables and power cords.
10 If you used the VESA Pass-through connector, run the FCON.EXE
utility in HPUtils to enable the connection.
34
English
Hide quick links:
Advertisement
Table of Contents
