Table of Contents
Advertisement
Audio-Output Volume settings
window (see
figure 35
consumer (-10 dBV) or professional (+4 dBu), for a single output or for all outputs and
allows you to change it. This window also displays the RGB delay settings and allows
you to change it and allows you to mute and unmute the video and audio output.
— Displays the RGB Delay/Mute/Output-Volume Adjust window
Mute-Output settings
(see
figure 35
on the preceding page), which allows you to mute and unmute the video
and audio output for a single output or for all outputs. This window also displays the
RGB delay and output volume level settings and allows you to change them.
...
Update Firmware
— Allows you to replace the firmware that is coded on the control
board of the switcher without taking the switcher out of service. See
firmware" on page 49.
— Allows you to name each of the 16 memory presets.
Name Presets
— Displays the ASCII commands that are used by the current
Show RS-232 Strings
configuration. You can refer to these for RS-232 programming.
— Initializes and clears any or all of the following: ties, presets, RGB delay,
Initialize
audio configuration, preset titles, icon names, and icons.
Audio Input Configuration selection
Displays the Configure Audio Options window (see
shows the audio gain level settings for each input and allows you to change them.
Preferences menu
— Causes changes to take effect immediately.
Immediate Changes
— Delays implementation of changes until the
Hold/Verify Changes
Changes – Take button is pressed.
— Displays ties as lines (see
Ties as Lines
Figure 37.
Ties Shown as Lines
MVX 44 / 48 / 84 / 88 VGA Matrix Switchers • Remote Operation
— Displays the RGB Delay/Mute/Output-Volume Adjust
on the preceding page), which displays the output volume level,
figure 36
figure
37).
"Updating the
on the preceding page), which
54
Advertisement
Table of Contents
