Table of Contents
Advertisement
Example 3: Remove a tie from a set of ties
In the following example, an existing tie is removed from the current configuration. The
example shows the front panel indications that result from your actions.
NOTE:
This example assumes that you have performed
1.
Select audio only for the tie: If necessary, press and release the I/O button to cycle
through the selections until the only the Audio LED lights.
The video LED is off when video is deselected.
The audio LED lights when audio is selected.
2.
Select an input: Press and release the input 5 button.
Press and release the Input 5 button.
INPUTS
4
5
6
The Input 5 LED lights to
indicate that input 5 is selected.
3.
Select the output: Press and release the output 4 button.
Press and release the Output 4 button.
1
2
3
The Output 4 LED goes out to indicate that the selected input will be untied from
this output.
4.
Confirm the change: Press and release the Enter button.
Press the Enter button to
The LED for the selected input and the LEDs for the remaining tied
confirm the configuration
outputs LEDs light steadily for approximately 1 second to indicate the
change.
tie and then go out. (The LED for the deselected output is already out.)
INPUTS
5
ENTER
The current configuration (see
•
Video — Input 5 video tied to output 1, output 3, output 4, and output 8
•
Audio — Input 5 audio tied to output 3 and output 8
Input 5 video tied
to outputs 1, 3, 4, and 8.
Input 5 audio tied
to outputs 3 and 8.
Input
5
1
3
Output
4
8
Figure 10.
Example 3 Configuration
Press the button.
I/O
VID
AUD
1
2
3
The Output 3, Output 4, and Output 8 LEDs light to indicate the ties created in
example 1.
OUTPUTS
4
5
7
6
OUTPUTS
3
4
1 second
figure
10) is now:
Video
Audio
MVX 44 / 48 / 84 / 88 VGA Matrix Switchers • Operation
example 1
and
example
OUTPUTS
4
5
6
7
8
8
2.
8
16
Advertisement
Table of Contents
