Pride STYLUS LS Owner's Manual page 22

I V . C O M F O R T A D J U S T M E N T S
Caster Angle
When you change the seat angle, you must also change the caster angle so that the caster barrels remain at a 90°
angle to the ground. There are three possible caster angles. See figure 25. If the front of the seat is higher than the
rear, the caster assembly should be in postion 1. If there is little or no seat dump (i.e., the seat is parallel to the
ground), the caster assembly should be in position 2. If the rear of the seat is higher than the front, the caster
assembly should be in position 3.
NOTE: There are two bolts that fasten the caster wheel assembly to the frame. The bolt shafts are offset to the
heads. The bolt shafts must be positioned either fore or aft relative to the holes.
To change the caster angle:
1. Remove the bolts that fasten the caster wheel assembly to the frame.
2. Reposition the bolts according to the table in figure 24.
3. Tighten the bolts.
NOTE: Make sure that both casters are adjusted to the same angle.
POSITION 1.
Figure 25. Caster Angle Adjustment
22
Caster Top Bolt Bottom Bolt
Position Position
1 Fore
2 Fore
3 Aft
Figure 24. Caster Angles
BOLT SHAFT
BOLT HEAD
FORE
POSITION 2.
www.pridemobility.com
Caster
Position Wheel Angle
Aft 95°
Fore 90°
Fore 85°
POSITION 3.
TOP BOLT
BOTTOM
BOLT
AFT
Stylus LS