Table of Contents
Advertisement
2
_________________________________________________________________________________________
2.0
Applicable standards and reference documentation
The drive has been developed as a system peripheral to the highest standards of design and construction. The
drive depends upon its host equipment to provide adequate power and environment in order to achieve optimum
performance and compliance with applicable industry and governmental regulations. Special attention must be
given in the areas of safety, power distribution, shielding, audible noise control, and temperature regulation. In
particular, the drive must be securely mounted in order to guarantee the specified performance characteristics.
2.1
Standards
The Hawk 2 Family complies with Seagate standards as noted in the appropriate sections of this specification
and the Seagate SCSI-2/SCSI-3 Interface Specification, P/N 77738479 (Vol. 2, Version 2).
The Hawk 2 Family is a UL Recognized component per UL 1950 and a CSA Certified component per CAN/CSA-
C22.2 No. 950-M89. It also meets the requirements of DIN VDE 0805/05.90 and EN60950: 1988 (IEC 950).
The Hawk 2, as delivered, is designed for system integration and installation into a suitable enclosure prior to
use. As such the Hawk 2 is supplied as a sub-assembly and is not subject to Subpart J of Part 15 of the FCC
Rules and Regulations nor the Radio Interference Regulations of the Canadian Department of Communications.
However, the unit has been tested using proper shielding and grounding and found to be compliant with Class A
limits of the FCC Rules and the Regulations of The Canadian Department of Communications.
The physical design characteristics of the Hawk 2 serve to minimize radiation when installed in an enclosure that
provides reasonable shielding. As such, the Hawk 2 is capable of meeting the Class B limits of the FCC Rules
and Regulations of the Canadian Department of Communication. However, it is the users responsibility to assure
that the Hawk 2 meets the appropriate EMI requirements in their system. Shielded I/O cables may be required if
the enclosure does not provide adequate shielding. If the I/O cables are external to the enclosure, shielded
cables should be used, with the shields grounded to the enclosure and to the host controller.
Caution.
To avoid potential service problems, observe the following precautions:
The Manufacturers installed labels must not be removed from the drive or covered with additional
labels, as they contain information required when servicing the product.
2.2
Applicable reference documents
Installation Guide
Product Manual - SCSI-2 Interface
ANSI Small Computer System Interface (SCSI): Document Number ANSI3.131-1986 (X3T9/84.40 Rev. 1B)
(X3T9.2/82-2 Rev. 17B) and X3T9.2/86-109 Revision 10H (SCSI-2).
Package Test Specification Seagate P/N 30190-001 (under 100 lb.)
Package Test Specification Seagate P/N 30191-001 (over 100 lb.)
In case of conflict between this document and any referenced document, this document shall take precedence.
Product Manual - Hawk 2 Family SCSI-2 (Volume 1), Rev. D
Seagate P/N 77767451
Seagate P/N 77738479
Advertisement
Table of Contents
