Installing Memory Modules - ECS Motherboard User Manual

3 Push the locking lever down and hook it under the latch
on the edge of socket.
4 Apply thermal grease to the top of the CPU.
5 Install the cooling fan/heatsink unit onto the CPU, and
secure them all onto the socket base.
6 Plug the CPU fan power cable into the CPU fan
connector (CPU_FAN) on the motherboard.

Installing Memory Modules

This motherboard accommodates two 184-pin 2.5V unbuffered
Double Data Rate SDRAM (DDR SDRAM) Dual Inline Memory
Module (DIMM) sockets, and supports up to 2.0 GB of 400 MHz
DDR SDRAM.
DDR provides 2.1 GB/s, 2.7 GB/s or 3.2 GB/s data transfer rate
when the bus is 266 MHz , 333 MHz or 400 MHz, respectively.
DDR uses additional power and ground lines and requires 184-pin
2.5V unbuffered DIMM module.
DDR2
DDR1
Chapter 2: Motherboard Installation
11