Table of Contents
Advertisement
Replacement
1. Follow the replacement procedure in the installation instructions
2. Reconnect the power and data cables.
3. Position the side access cover on the screws to engage the keyhole
4. When the screws have properly engaged the keyhole slots, slide the
http://www.mcg.mot.com/literature
Figure 5-2. Disk/Tape Drive Removal
that came with your drive.
Note: Use the short (1/4 inch long) screws to attach the brackets to
the drive. The longer screws may damage the drives. Ensure that all
drives are properly identified and that the terminating resistor is
installed or removed as applicable.
slots properly. The washers must be on the outside of the cover.
cover down and tighten the screws.
Disk and Tape Drive
11823.00 9708
5-7
5
Advertisement
Table of Contents
