Overview; Following Esd And Safety Procedures - Motorola MVME956AC User Manual

5Removal and Replacement

Overview

This chapter provides recommended procedures for the removal and
replacement of MVME956AC chassis major assemblies. For
identification and location of the assemblies and parts mentioned in these
procedures, refer to the drawings and parts lists in
The removal/replacement procedures are organized and presented in the
following order:

Following ESD and Safety Procedures

Motorola strongly recommends that you use an antistatic wrist strap and a
Use ESD
conductive foam pad when installing or upgrading the system. Electronic
components, such as disk drives, computer boards, and memory modules,
can be extremely sensitive to ESD. After removing the component from
the system or its protective wrapper, place the component flat on a
Wrist Strap
grounded, static-free surface, and in the case of a board, component-side
up. Do not slide the component over any surface.
If an ESD station is not available, you can avoid damage resulting from
ESD by wearing an antistatic wrist strap (available at electronics stores)
that is attached to an unpainted metal part of the system chassis.
Power Supply
Disk and Tape Drive
VME64x Bus Backplane
Cooling Fan(s)
Optional Air Filter Kit
Procedures
Chapter
5
7.
5-1