Table of Contents
Advertisement
Chassis Mount Options
Rack Mounting Option
2
2-4
The MVME956AC can be mounted, along with other equipment, in a
standard 19-inch RETMA (or equivalent) rack. If the chassis is equipped
with the benchtop cover kit, you must first remove it.
Cover Kit Removal
1. The top and side panels are attached with ball stud pop-on, pop-off
catches. Remove the top panel by grasping the panel at the edges
and lifting it straight up from the chassis.
2. Remove the side panels by firmly grasping each panel and pulling it
straight out from the chassis.
3. Remove the ball studs from the top and sides of the chassis.
4. Remove the disk drive cover from the front opening.
To rack mount the MVME956AC unit, you must use the optional slide
mounting kit, MVME946RKMT. Be sure to observe and follow the special
cooling requirements explained in
To rack-mount an MVME956AC chassis, follow the procedure below.
1. Install the two chassis slide sections as shown in using the binder-
head screws that came in the kit. The right and left sections are
identical.
2. Determine where you will mount the chassis in the rack and how
much space is required for mounting. Install the rack slide rails in
the equipment rack using the binder-head screws and barnuts
supplied. The chassis can now be installed in the rack.
Note: The rack slide rails (18-5/8 inches) must coincide with that of
the chassis slide rails.
3. Align the chassis slide sections with the two rack-mounted slide
sections.
4. While depressing the loc/stop buttons on the chassis slide sections,
slide the chassis into the rack. Adjust the slide mounting hardware
until the chassis slides in and out smoothly.
Chapter
1.
Computer Group Literature Center Web Site
Advertisement
Table of Contents
