Emptying The Drip Tray - Morphy Richards 47586 Instructions Manual

CM172004MEE Rev1.qxp_Morphy Richards Instruction Book 16/02/2015 15:05 Page 6
g
Features
A
1 Water Tank Lid
2 Water Tank
3 Coffee Ready Light
4 On/Off Light
5 Steam Ready Light
6 Coffee Dispense Button
7 On/Off Button
8 Steam Button
9 Steam Control
10 Brewing Head
11 Steam Wand (with cover)
12 Drip Tray and drip tray grid
13 Empty Drip Tray Indicator
14 E.S.E. Pod Filter
15 7g Coffee Filter (for single shot use)
16 14g Coffee Filter (for double shot use)
17 Filter Holder
18 Tamp Spoon
Using Your Coffee Maker
Your Meno Espresso uses ground coffee or Easy Serving
Espresso (E.S.E.) pods and comes with three suitable Filter
Holders. The 7 g Filter Holder (15) is for single shot use and the
14g Filter Holder (16) is for double shot use. Use the E.S.E. Pod
Filter (14) when using E.S.E. pods - a compact coffee pod with
a paper filter covering.
Assemble the Meno Espresso as above. Fill the Water Tank up to
1
the MAX line, (1.25L)
Place the required filter into the Filter Holder, (17) add the coffee
2
grinds and tamp, alternatively insert the E.S.E. pod.
Place the Filter Holder into the Brewing Head and turn to lock into
3
position.
4 Plug the Meno Espresso in and press the On/Off button (7) wait
for the Ready Light toilluminate. (3)
5 When the Meno Espresso is ready, place cups on the Drip Tray
and press the Coffee Dispense Button. (6)
Press the Coffee Dispense Button (6) again to stop the coffee.
6
7 Empty the coffee grinds/ E.S.E pod, remove the Filter from the
Holder and clean.
Standby
After the brewing cycle has finished your Espresso maker will
switch to standby for 30 minutes
To reactivate. Press the On/Off Button
6
Using the Steam Wand
Fill the Water Tank and press the On/Off Button (7). Wait for the
8
Ready Light to illuminate (3).
Press the Steam Button, (8) wait for the Steam Light to illuminate
9
(5).
1 0 Pour 100-200ml of chilled milk into a jug.
1 1 Place the Steam Wand (11) into the milk, slowly turn the Steam
Control (9) to on.
1 2 When enough froth has been produced, turn the Steam Control to
off.
1 3 Press the Steam Button to exit the steam function. Serve the
frothy milk.
1 4 To clean, remove the wand cover and use a wet cloth to clean the
wand and cover.
1 5 Use a pin to clean the nozzle head, and air holes in the cover.
WARNING
WHEN FROTHING MILK ENSURE THE STEAM CONTROL IS
OFF BEFORE REMOVING THE WAND FROM THE MILK.

Emptying the drip tray

1 6 When the water in the Drip Tray is full, the Empty Drip Tray
Indicator (13) will be visible
1. Remove the Drip Tray from the appliance and empty.
2. Clean the Grid and Drip Tray with a damp cloth before replacing.
Cleaning your Meno Espresso
1 Disconnect the appliance from the mains supply.
2 Make sure the appliance has completely cooled down.
3 Simply wipe the Steam Wand and exterior with a clean, damp
cloth.
Do not use any abrasives or metal scourers as this will damage
the finish on the unit.
4 The Filter Holder and Water Tank should be washed after each use
by rinsing them under water. To assist in keeping the Filter Holder
clean we recommend you periodically run the machine with the
Filter Holder in place, without coffee, using water only.
Should the holes in the filter become blocked with coffee grinds,
use a fine bristled brush to help clean.
When your coffee maker is not being used, we recommend that
you do not leave the filter holder attached to the machine as this
will reduce the life of the gasket.
5 Remove the Drip Tray Grid and Drip Tray from the appliance and
remove any spilt coffee and water then clean them with a damp
cloth or a damp sponge.
6 You must clean the Steam Wand and cover
immediately after each use, after it has cooled down. Briefly use
the steam setting to clear any remaining milk out of the Wand and
Cover.
Remove the Steam Wand Cover, place under warm running water
to remove excess milk. If the Steam Wand becomes blocked, use
a small pin to clean more thoroughly.