Before First Use; Setting The Clock - Morphy Richards Vector Quick Start Manual

CM163002 MUK REV1.qxp_Layout 1 22/08/2017 10:32 Page 5

Before First Use

• Take your coffee maker out of the box and
remove the packaging.
• Wash the detachable parts (removable permanent
filter, removable filter holder, glass carafe) in warm
soapy water.
Using Your Coffee Maker - Quick Start
Fill the Water Reservoir
using the internal water ladder
guidance. Fill water to the required amount of
cups that you would like to produce. Do not
exceed the maximum 12 cups level.
Close the Lid (1)
on the Hot Plate (6).

Setting the Clock

• To set the machine to display the time of day,
follow the steps below. Please note this does not
set the coffee brew time. To set the brew time,
follow the instructions on page 6.
When your coffee maker is plugged in, the display
1
will illuminate.
(9) with cold water
(3) for
and replace the Carafe (5)
• The first time you use your coffee maker, operate
the coffee maker with water only.
• The lid (1) may be stiff to open for the first few
uses. We recommend that you steady the side of
the machine with one hand, and lift the lid with
the other hand, for ease of opening.
1
Spoon filter coffee into the Removable
Permanent Filter (7). We recommend 7g
(approx 1 scoop) of coffee per cup. Place the
Filter into the Removable Filter Holder
ensuring the Removable Filter Holder aligns
into place. The Removable Permanent Filter
does not require an additional paper filter.
However, you can use a paper filter too, if you
choose, but ensure it is suitable for a cupcake
shaped filter and matches the dimensions of
the Removable Permanent Filter.
3
Press the On/Off Button
brewing process. If you need to stop the brewing
process, press the button a second time.
DO NOT OPEN THE LID
BREWING CYCLE.
To set the time, press and hold the
2
Program/Clock Button
the Select Up & Down
the time. The display is a 12 hour clock.
Press the Program/Clock Button
3
confirm the time.
2
(8)
4
(16) to start the
(1) DURING THE
(11) for 3 seconds and use
(14 & 15) Buttons to adjust
(11) again to
5