Two-Car Operation - Code Alarm Professional 1000 Owner's Manual

,
o
The valet function allows you to prevent the system from arming when
vehicle is being serviced or parked by a valet. To operate. simply
disarm the system then turn the valet switch to the "ON·" position before
arming the system. The system will remain in the valet state as long
as the valet switch remains in the "ON" position. The system will arm
normally when the valet switch is returned to the
"Q!!"
position.
the alarm is in the valet state. the L.E.D. indicator will flash in a
blink sequence (2-blinks "on"; then "off" ... ). In valet state your remote
control transmitter will still lock and unlock your doors but will not arm
your vehicle. It \/iiill only emit one chirp as if an entry point was left open.
Some states do not allow a premium insurance discount for alarm
equipped vehicles when the service/valet override switch is used. Check
with
REMOTE CONTROL PANIC BUTTON OPERATION
f!
With the system armed or disarmed. press both buttons on the remote
control transmitter at the same time. The siren will turn on and remain
active for 30 seconds. The siren can be turned off before 30 seconds
by pressing any button on the remote control transmitter.
Your system is capable of
recognizing 4 different transmit-
ters having 4 different codes.
o
TWO-CAR OPERATION:
In
this mode each transmitter can
control two cars. Both cars must
have alarms with 2 car capability.
ARMI
~
ARMI
DISARM . DISARM
CAR 1 CAR 2
PRESS AND HOLD
DISARM BUTTON
FOR TRUNK