Operation Of The Monitor - Fujitsu 68.6 cm (27") Operating Manual

LCD monitor
Plug the power connector of the computer into a properly grounded mains outlet.
When you start working with your monitor for the first time you should install the
i
appropriate graphics drivers for your application software. Details of how to do this are
provided in the documentation on your screen controller/the associated driver software.

Operation of the monitor

For displays with glossy bezels the user should consider the placement of the display as
i
the bezel may cause disturbing reflections from surrounding light and bright surfaces.
Adjusting rake
The rake of the monitor can be adjusted forward and back from its vertical position.
Grasp the monitor with both hands on the right and left edge of the casing and adjust it to the
desired rake.
Switching the monitor on/off
The ON/OFF switch is used for switching the monitor on and off.
The power indicator glows green or blue when the monitor and computer are switched on. The power
indicator glows orange when the monitor does not receive a video signal or is in energy-saving mode.
The power indicator goes off when the monitor is switched off.
When you switch the computer system on, you must proceed in the following order:
First switch the LCD monitor on with the ON/OFF switch.
Then switch on the computer.
Fujitsu Technology Solutions
1
2&3
1 = Buttons for the OSD menu
(On-Screen-display)
2 = Power indicator
3 = ON/OFF switch
English - 9
21