Adjust The Two-Position Viewing Angle - NEC SL1100 User Manual

Before using Your Terminal...
Thank you for purchasing NEC SL1100 system.
Due to the flexibility built into the system, your Dialing Codes and Feature Capacities may differ
from those in this guide. Check with your NEC Authorized Supplier / System Administrator and
make a note of any differences.
Installing the Handset and Line Cord
Cord can be installed
either way

Adjust the two-position Viewing Angle

To set the low viewing angle position:
1. Fold the legs all the way back.
NEC Corporation reserves the right to change the specifications, functions, or features at any time without notice.
NEC Corporation has prepared this document for use by its employees and customers. The information contained
herein is the property of NEC Corporation and shall not be reproduced without prior written approval of NEC
Corporation.
Handset Cord
To set the high viewing angle position:
1. Flip up the two leg supports.
2. Fold the legs back until the supports contact the base.
Copyright 2011- 2012, NEC Corporation
Printed in Japan
1
When installing the handset :
1. Make sure the handset cord is plugged into
the handset jack on the telephone base.
2. The line cord routes through the channel on
the telephone base.
3. Alternatively the line cord can route through
the channel on the telephone legs.