Fuel Filter Replacement - Chicago Electric 98391 Set Up, Operating, And Servicing Instructions

Chicago electric diesel generator
Table of Contents

Advertisement

air Filter element Maintenance
1.
Routine maintenance to the air
cleaner helps maintain proper airflow
to the engine. Service the air cleaner
according to the following steps every
250 or 500 hours, or more often when
using the generator in a dusty area.
2.
Wipe off the air cleaner cover.
3.
Remove the air cleaner maintenance
panel by unscrewing the bolts with
10-mm wrench.
4.
Remove the wing nut from the bolt
holding the air cleaner cover. Re-
move the air cleaner cover.
5.
Take out the used air cleaner ele-
ment. Replace with a new element.
6.
Reinstall the air cleaner cover, tighten
the wing nut, then screw back the air
cleaner maintenance panel.

Fuel Filter replacement

warning! to prevent
serious injurY FroM
Fire:
Replace the fuel filter in a
well-ventilated area away from igni-
tion sources. Do not smoke.
1.
Wait for engine to cool completely
before proceeding.
2.
Wear protective gear including, ANSI-
approved safety goggles.
3.
Turn the fuel valve to the "off" posi-
tion.
4.
Unscrew the bolt holding the fuel filter
to the frame using a 13 mm wrench.
Pull the fuel valve/filter assembly out
of the enclosure. Place a bucket un-
der the assembly to catch the fuel.
SKU 98391
For technical questions, please call 1-800-444-3353.
5.
Remove the fuel filter cup, and the
filter element.
6.
Clean the cup of all sediment using a
rag or brush.
7.
Replace the fuel filter element
8.
Reinstall the fuel filter element, fill
the cup with fresh and clean diesel
fuel and assemble per stps 5 and 4
above.
9.
Open the fuel valve until the filter is
filled.
10.
Remove the hose clamp and slightly
remove fuel outlet hose to purge out
any trapped air in the line. Re-attach
the hose and clamp.
11.
Remove four screws and Injector
Inspection Cover (49) from top of
Sound Shield Panel (41). Place a
clean rag under the injector inlet and
using two wrenches loosen input line
nut by one turn. Tap starter to force
fuel out of injector line. When air
bubbles stop, re-tighten the input line
nut.
REV 09a
Page 17

Advertisement

Table of Contents
loading

Table of Contents